본 연구에서는 산화제와 계면활성제를 이용한 산화 및 세척처리방법의 해양오염퇴적물에 함유된 PCBs에 대한 처리 가능성과 그 정도를 평가하였다. 본 연구를 위하여 해양오염퇴적물 정화사업이 예정된 국내 세 해역을 선별하여 오염퇴적물시료를 채취하였다. 대상 오염퇴적물의 입경별 오염분포는 유기물 및 PCBs농도가 퇴적물의 입경이 작을수록 증가하는 경향을 보였다. 대상해역의 퇴적물의 처리는 산화제인 H₂O₂, KMnO₄ 5M과 계면활성제인 Triton X-100 0.05%를 퇴적물과 1:3의 비율로 각각 1시간동안 회분식 처리하여 퇴적물 내 PCBs제거효율을 확인하였다. 전체 퇴적물에서 H₂O₂, KMnO₄ 및 Triton X-100의 PCBs제거효율은 각각 평균 10, 24, 19%로 PCBs제거의 가능성을 확인하였으며 KMnO₄의 제거율이 가장 높았다. 그러나 미세입자의 PCBs 제거율은 미비하거나 오히려 PCBs농도가 증가하여, 해양오염퇴적물의 PCBs정화에 적용하기 위해서는 개선이 필요한 것으로 나타났다.
Feasibility of marine sediments contaminated with PCBs was investigated on the basis of washing technology using oxidizers and surfactants. Tested sediment samples were collected from three contaminated marine sites in South Korea. The organic contents and PCBs in sediments were associated with grain size, and the highest level of the organic contents (COD, IL, TOC and TN) and PCBs were found in <32 ㎛ or 32-63 ㎛ fraction. Oxidizers, H₂O₂ and KMnO₄ (5M), and a non-ionic surfactant, Triton X-100 (0.05%), were used to remove PCBs in the contaminated marine sediments at 1:3 solid liquid ratio for 1 hour. The observed removal efficiency of PCBs by H₂O₂, KMnO₄ and Triton X-100 were 10, 24, and 19%, respectively. The experimental results suggest that KMnO₄ is most effective chemical to remove PCBs and TOC in contaminated marine sediments. However, PCBs in <63 ㎛ fraction did not be removed or even increased. Our experimental results elucidated that the remediation method of this research, based on washing technology using oxidizers and surfactants for PCBs removal from the contaminated sediments, could be possible however, further improvement and optimization might be also needed to remove PCBs from fine the particle fractions, <63 ㎛.